AMagic AES-S3505UE Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Festplatten-Arrays AMagic AES-S3505UE herunter. AMagic AES-S3505UE User`s manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken

Inhaltsverzeichnis

Seite 1 - RAID Enclosure

USB & eSATA comboRAID Enclosure Storage Appliance AES-S3505UE User’s Manual October 7, 2009

Seite 2 - Table of Contents

It is also possible to create a LARGE volume using only a single hard disk drive connected to Port 1. However, it is not possible to expand an exist

Seite 3

2.1.4 R0 MODE The R0 MODE storage policy distributes access across all hard disks. R0 MODE presents the best data speed but no data redundancy. R0

Seite 4 - 1 WELCOME

access takes precedence over the rebuild process. If you continue to use the R1 volume during the rebuild, the rebuild process will take a longer tim

Seite 5 - 1.3 FEATURES

drive. There are at least 3 members to a virtual R3 volume. The following example illustrates how the parity is rotated from drive to drive. The R3

Seite 6 - 1.4 SPECIFICATIONS

The R5 MODE uses less capacity for protection and is the preferred method to reduce the cost per megabyte for larger installations. In exchange for

Seite 7 - 1.5 SYSTEM REQUIREMENTS

3 INSTALLATION 3.1 INSTALLING HARD DISK DRIVE Please refer below procedure to complete the HDD installation. • Open the drive door than unlock the H

Seite 8 - 1.6 PRODUCT CONTENTS

• Close the drive door to complete hard drive disk installation. 3.2 POWER ON / OFF • Push the power button to power on, and push again to power of

Seite 9 - 2 STORAGE POLICIES

3.4 INSTALLING HOST BUS ADAPTER (OPTIONAL) 3.4.1 WINDOWS XP (32/64-bit) 1. Select No, not this time, than click Next. 2. Select Install the softwa

Seite 10

3. Click Finish to complete installation. 3.4.2 WINDOWS VISTA (32/64-bit) 1. Click Locate and install driver software (recommended). Ver. 0

Seite 11

2. Click Next for next step. 3. Click Close to complete installation. AES-S3504UE User’s Manual Ver. 091007 19

Seite 12

Table of Contents 1 WELCOME...

Seite 13

3.4.3 WINDOWS 7 RC2(32-bit) 1. Go to the Device Manager. 2. Right click on the Mass Storage Controller, than Select Update Driver Software.

Seite 14

3. Click Browse my computer for driver software. 4. Browse to select the 32bits folder from the Repository CD to begin the installation (Located at:

Seite 15 - 3 INSTALLATION

5. Click Finish to complete installation. 3.4.4 WINDOWS 7 RC2(64-bit) 1. Go to the Device Manager. Ver. 091007 AES-S3504UE User’s Manual

Seite 16 - 3.2 POWER ON / OFF

2. Right click on the Mass Storage Controller, than Select Update Driver Software. 3. Click Browse my computer for driver software. AES-S350

Seite 17

4. Browse to select the 64bits folder from the Repository CD to begin the installation (Located at: E:\Driver\SiI3132\Windows\64bits PS: "E:&quo

Seite 18

3.4.5 MACINTOSH OS TIGER 10.4.X / LEOPARD 10.5.X / SNOW LEOPARD 10.6.X 1. Insert the Setup and Installation Repository Driver CD in the CD-ROM drive

Seite 19

4. Once started, the following dialog screens will appear, Click Continue. 5. Read the Read Me file, than click Continue. Ver. 091007 AES-S3

Seite 20

6. Read the Software License Agreement, than click Continue. 7. Click Agree to continue the installation. AES-S3504UE User’s Manual Ver. 091

Seite 21

8. Select a destination volume to install the software, than click Continue. 9. Click Install to begin the installation. Ver. 091007 AES-S35

Seite 22

10. Enter the Administrative Password for your system, than click OK. 11. Click Close to complete the installation. AES-S3504UE User’s

Seite 23

4.5 LED INDICATIVE STATUS...31

Seite 24

4 CONFIGURATION 4.1 CONFIGURATION PREREQUISITES 4.1.1 SATA HOST CONNECTIONS This guide assumes that you have already attached the aMagic AES-S350

Seite 25

2. A message will appear listing all of the devices that the Eject icon controls. Click on the “Safely remove USB Mass Storage Device” item. 3. The f

Seite 26

4.5.1 POWER LED The aMagic AES-S3505UE has one Amber color Power LED. The table shows Power LED function and operation. DESCRIPTION GREEN LED Power

Seite 27

4.6 MODE SETTING The aMagic AES-S3505UE with the device’s LEDs to indicate status. To select a storage policy in this mode the first time that a new

Seite 28

4. Turn on the power than release the SETUP BUTTON to complete mode setting. 4.6.2 LARGE MODE The LARGE MODE storage policy requires a minimum of 2

Seite 29

4. Turn on the power than release the SETUP BUTTON to complete mode setting. 4.6.3 CLONE MODE The CLONE MODE storage policy requires a minimum of 2

Seite 30 - 4 CONFIGURATION

4. Turn on the power than release the SETUP BUTTON to complete mode setting. 4.6.4 CLONE MODE WITH HOT SPARE The CLONE MODE storage policy with hot

Seite 31 - 4.5 LED INDICATIVE STATUS

4. Press and hold the recessed SETUP BUTTON. 5. Turn on the power than release the SETUP BUTTON. 6. Turn off the power. 7. Insert the hotspare dri

Seite 32

8. Turn on the power to complete mode setting. 4.6.5 R0 MODE The R0 MODE storage policy requires a minimum of 2 drives to implement. 1. Turn off th

Seite 33 - 4.6 MODE SETTING

4. Turn on the power than release the SETUP BUTTON to complete mode setting. 4.6.6 R1 MODE The R1 MODE storage policy requires 2 drives to implemen

Seite 34

1 WELCOME 1.1 INTRODUCTION Thank you for choosing aMagic AES-S3505UE storage appliance. It is a low-cost solution for digital home and small office s

Seite 35

4. Turn on the power than release the SETUP BUTTON to complete mode setting. 4.6.7 R1 MODE WITH HOT SPARE 1. Turn off the power. 2. Insert 3 drive

Seite 36

4. Press and hold the recessed SETUP BUTTON. 5. Turn on the power than release the SETUP BUTTON to complete mode setting. 4.6.8 R10 MODE The R10 M

Seite 37 - 6. Turn off the power

3. Press and hold the recessed SETUP BUTTON. 4. Turn on the power than release the SETUP BUTTON to complete mode setting. 4.6.9 R10 MODE WITH HOT

Seite 38

3. Set the MODE SWITCH position to R1/R10. 4. Press and hold the recessed SETUP BUTTON. 5. Turn on the power than release the SETUP BUTTON to compl

Seite 39

2. Set the MODE SWITCH position to R3. 3. Press and hold the recessed SETUP BUTTON. 4. Turn on the power than release the SETUP BUTTON to complete

Seite 40

2. Insert 3 drives in order from the top to the bottom. 3. Set the MODE SWITCH position to R3. 4. Press and hold the recessed SETUP BUTTON. 5. Tur

Seite 41

6. Turn off the power. 7. Insert the hotspare drive into the 4th HDD bay. 8. Turn on the power to complete mode setting. 4.6.12 R5 MODE The R5 MOD

Seite 42 - 1. Turn off the power

2. Set the MODE SWITCH position to R5. 3. Press and hold the recessed SETUP BUTTON. 4. Turn on the power than release the SETUP BUTTON to complete

Seite 43

2. Insert 3 drives in order from the top to the bottom. 3. Set the MODE SWITCH position to R5. 4. Press and hold the recessed SETUP BUTTON. 5. Tur

Seite 44

6. Turn off the power. 7. Insert the hotspare drive into the 4th HDD bay. 8. Turn on the power to complete mode setting. 4.7 REBUILDING A REDUNDA

Seite 45

1.2 PRECAUTION Please read the safe precautions carefully before you using aMagic AES-S3505UE storage appliance. Ensure that you use the product corr

Seite 46

4.7.1 REBUILDING A REDUNDANCY DRIVE 1. If the drive 2 has breakdown, please remove the breakdown drive 2. 2. Turn off the power. 3. Replace a same

Seite 47

4.7.2 REBUILDING A HOT SPARE DRIVE 1. If the there is a hot spare drive on drive 5, and the drive 2 has breakdown, the hot spare drive on drive 5 wi

Seite 48

5 PARTITIONING VOLUMES 5.1 PARTITION A VOLUME 5.1.1 WINDOWS SYSTEMS Note: Before repartition a volume, back up your data and delete previously defi

Seite 49

opens with the selected disk (all Unknown disks may appear in this window). Make sure the box next to each disk is checked and click OK. The disk sho

Seite 50

4. Click Next to start the Partition Wizard. 5. Select the Primary or Extended option and click Next. Ver. 091007 AES-S3504UE User’s Manua

Seite 51

6. Specify the partition size. By default, the partition occupies the entire volume. Click Next. 7. Assign a drive letter or mount path and click N

Seite 52 - 5 PARTITIONING VOLUMES

8. Name and format the partition and click Next. 9. Review the file system settings and click Finish to create the logical partition. Ver. 09

Seite 53

10. Repeat steps 1 through 9 to partition any remaining disks. 5.1.2 MACINTOSH SYSTEMS Note: Before reconfiguring a volume, back up your data and d

Seite 54

2. Select a configured disk and click the Partition tab. This procedure illustrates the LARGE Storage Policy configuration, which concatenates the ca

Seite 55

Disk Utility mounts the created partition and represents it with an icon on the desktop. The icon is labeled with the partition name. 9. Repeat ste

Seite 56

1 host port (eSATA or USB) to 5 Serial ATA hard disk drives. Compatible with SATA Gen1 and Gen2 host controllers. Compatible USB 2.0 specificat

Seite 57

6 APPENDIX 6.1 FAQ If you need some help for troubleshooting, please check the frequently asked question below, it may help you problem solved quickl

Seite 58

Manufacturer Capacity Family Part Number Firmware Hitachi 250GB Deskstar™ 7K250 HTS54252K9SA00 BBFOC31P Hitachi 160GB Deskstar™ 7K80 HDS72180PLA3

Seite 59

Manufacturer Capacity Family Part Number Firmware Seagate 160GB Barracuda® 7200.7 Serial ATA ST3160827AS 3.42 Seagate 160GB SV35 ST3160812SV 3

Seite 60 - 6 APPENDIX

6.3 MOTHERBOARD COMPATIBILITY LIST The AES-S3504UE Storage Appliance has been tested compatibility with a range of motherboard manufacturer. The tab

Seite 61

Manufacturer Product North Bridge South Bridge BIOS GIGABYTE GA-73PVM-S2H NVIDIA GEFORCE 7100 MCP73 F7A GIGABYTE GA-M78SM-S2H NVIDIA GEFORCE

Seite 62

282 (L) x 150 (W) x 215 (H) mm, NW: 4.1 Kgs, GW: 5.3Kgs. 250 watts power supply, 100 to 132Vac or 200 to 264Vac select switch / 47~63Hz with CE/

Seite 63

drivers with Port Multiplier support • USB connection: USB 1.0 or 2.0 direct host connection or USB hub 1.6 PRODUCT CONTENTS The following parts are

Seite 64

2 STORAGE POLICIES You can configure the AES-S3504UE storage appliance to use any of the following storage policies to map the appliance’s physical

Kommentare zu diesen Handbüchern

Keine Kommentare